Rodgers Instruments W-5000 Betriebsanweisung PDF herunterladen (Seite 115)

Appendix

115

[MIDI] Parameters

These parameters allow you to set MIDI functions when external MIDI devices are being used. Press the

[MIDI] button in the desired section (UPPER, LOWER or BASS) to access these parameters:

Upper/Lower/Bass MIDI

Port: 1, 2

This parameter allows you to select the MIDI OUT port to be used for data transmission. Use the [+] and [-]

buttons to select the port.

Channel: 1-16

This parameter allows you to select the channel on which MIDI data will be transmitted. Press the [NEXT]

button to select this parameter. Use the [+] and [-] buttons to set the MIDI channel.

Prg: 0-128 Bnk: 0-127

The first parameter allows you to determine which Program Number will be transmitted. Press the [NEXT]

button to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons to set the Program Number. Press the

[NEXT] button to select the Bank (Bnk) parameter. Use the [+] and [-] (or [++]/[--]) buttons to set the Bank

Number. (A Prg or Bnk Number of '0' means that no Program Change or Bank select messages are

transmitted.)

Bnk LSB: 0-127

This parameter allows you to determine which LSB Bank (Control Change 32) will be transmitted. Press the

[NEXT] button to select this parameter. Use the [+] and [-] (or [++]/[--]) buttons to set the Bank LSB

Number.

Transpose: -127-127

This parameter allows you to set the amount of pitch transposition in the MIDI data. Press the [NEXT]

button to select this parameter. Use the [+]/[-] (or [++]/[--]) buttons to make the transposition setting.

Min Note: C0-G10

This parameter allows you to determine the lowest note number in the active range. Use the [+]/[-] (or

[++]/[--]) buttons to set the minimum note number.

Max Note: C0-G10

This parameter allows you to determine the highest note number in the active range. Use the [+]/[-] (or

[++]/[--]) buttons to set the highest note number.

Volume: 0-127

This parameter allows you to set the volume of transmitted MIDI data. Press the [NEXT] button to select this

parameter. Use the [+]/[-] (or [++]/[--]) buttons to set the volume.

Rev: 0-127

This parameter allows you to determine the reverb level. Use the [++] and [--] buttons to set the reverb level.

Cho: 0-127

This parameter allows you to determine the chorus level. Use the [++] and [--] buttons to set the chorus level.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 164 165

Keine Kommentare

Rodgers Instruments W-5000 Betriebsanweisung Seite 115