Rodgers Instruments W-5000 Betriebsanweisung PDF herunterladen (Seite 88)

Chapter 8

INPUTS

AUX INPUTS (XLR)

These XLR connectors allow you to connect a variety of external devices to your W-5000. These include

other keyboard instruments, mixing consoles or microphones. The signals input to the W-5000 can be routed

through the on-board reverb unit and then directed to one or more of the output connectors.

AUX INPUTS (1/4")

These extremely versatile 1/4" jacks accept connection of a wide variety of devices including external sound

modules, electronic instruments or microphones. The signals input to the W-5000 can be routed through the

on-board reverb unit and then directed to one or more of the output connectors.

SW1 (1/4")

This jack accepts connection of an external footswitch (usually a switched (on/off) controller).

PEDAL (1/4")

This jack accepts connection of an external footswitch (such as another Expression pedal).

ACC POWER (1/4")

This jack is a general purpose 12 volt output. External equipment (like a Rodgers PR-300) can be powered

from this jack.

All of the parameters (including sensitivity adjustments, stereo pan locations, reverb/chorus levels, signal

routing and so on) for the audio system (internal and external) are accessible through the [AUDIO] button in

the FUNCTIONS section. Please refer to page 130 for a complete list of audio parameters. Please refer to

'Specifications' on page 161 for details regarding the W-5000's internal audio system. Finally, an Audio

Block Diagram can be found on page 160.

SPEAKER AND LINE MIXES

THE SPEAKER MIX

The [SPKR] knob, as you will know, controls the overall volume of the instrument's internal speakers. The

sound that comes from the internal speakers is a mix of various sources, primarily the Classic Organ, Tone-

Wheel/Drawbar and Synth generators. If you like, you can adjust the relative levels of each of these internal

sources using the corresponding parameters accessed by pressing the [AUDIO] button in the FUNCTIONS

section:

Audio Syn

Spkr Mix: 0-127

This parameter allows you to determine the level of the Synth sounds in the overall Speaker mix. Press

[NEXT] as necessary until this parameter appears in the LCD. Set the volume level with the [+]/[-] (or

[++]/[--]) buttons.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 164 165

Keine Kommentare

Rodgers Instruments W-5000 Betriebsanweisung Seite 88