Rodgers Instruments W-5000 Betriebsanweisung PDF herunterladen (Seite 17)

Introduction & Installation

INSTALLING THE PEDALBOARD

Once the instrument is secured to the stand, it will be necessary to install the Pedalboard.

First, however, free the two pedal cables that are temporarily secured by a fastener to the underside of the

stand. (Do not remove this fastener from the base of the instrument. Before moving the W-5000, be sure that

these cables are carefully bundled (without any slack) and secured to the base using the fastener.) [NOTE:

Refer to the following page for information on pedalboard installation for the "A" version of the W-

5000.]

SPKR

LINE

- +

NOTE: If your W-5000 is sitting on a very thick carpet, it may be difficult to slide the Pedalboard into place.

If that is the case, very carefully lift one side of the instrument and rotate the adjustable feet to provide more

clearance. Then lift the other side and do the same. Take great care when making this adjustment; this

500 pound instrument could cause severe injury if it were to pinch fingers or toes!

Ê Connect the pedal cables to the

receptacles on the right side of the

Pedalboard assembly; one is a 5-

pin cable for the Pedalboard) and

the other is an 8-pin cable (for the

Expression pedal).

Ë Push the pedalboard (from the

center of the heelpad) so it slides

all the way into the stand.

5-pin 8-

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 164 165

Keine Kommentare

Rodgers Instruments W-5000 Betriebsanweisung Seite 17