Rodgers Instruments W-5000 Betriebsanweisung PDF herunterladen (Seite 136)

Chapter 10

136

MIDI Mst Out Flt

P: None, PC, CC, CC+PC, Note, PC+Note, CC+Note, All

This parameter allows you to determine what type of information will be filtered out of the data transmitted

by the Pedal section. Press [NEXT] to select this parameter. Use the [+] and [-] buttons. (See 'Using MIDI',

starting on page 96, for details on possible values.)

MIDI Mst Out Exp

CC#: 7, 11

This parameter allows you to determine which Control Change message is transmitted to the MIDI Master

Output when you move the W-5000's Expression pedal. Press [NEXT] to select this parameter. Use the [+]

and [-] buttons.

MIDI Drum In

Port: 1, 2

This parameter allows you select which MIDI port incoming percussion data will be received through. Press

[NEXT] to select this parameter. Use the [+] and [-] buttons. (The note data (and Program Change data for

Drum Sets) received via this port are mixed with [MANUAL DRUM] events. Therefore, the Manual Drums

Volume mappable destination will affect the volume of drums coming from this port as well.)

MIDI Drum In

Channel: 1-16

This parameter allows you to select which MIDI channel percussion data will be received on. Press [NEXT]

to select this parameter. Use the [+] and [-] buttons. (Channel 10 is normally used to handle percussion data.)

MIDI Drum In

Filter: None, PC, CC, CC+PC, Note, PC+Note, CC+Note, All

This parameter allows you to select which type of incoming data will be filtered. Press [NEXT] to select this

parameter. Use the [+] and [-] buttons. (See page 91 (in 'Using MIDI') for details on possible values, except

for 'PC' which in this case indicates Drum Set selection, not General Preset selection.)

MIDI Output

Initialize (+)

This parameter allows you to initialize any external sound module(s) connected to the W-5000. This function

should be performed immediately after you're started recording with an external sequencer. Press (+) to

proceed.

[UTILITY] Parameters

These parameters control a variety of overall system functions. Press the [UTILITY] button in the

FUNCTIONS section to access these parameters. Note that the Time and Date is initially displayed when the

[UTILITY] button is pressed.

Master Tune: -50-50 (cents; 1/100 of a semitone)

This parameter allows you to tune the W-5000 to match the pitch of other instruments. Press [NEXT] to

select this parameter. Use the [+] and [-] buttons to tune the instrument. (Selecting this parameter also results

in GS tuning messages being sent over ports selected for the UPPER, LOWER and BASS [MIDI] layers.

This data, however, is NOT recorded in a sequence.)

LCD Contrast: 0-9

This parameter allows you to adjust the LCD contrast. Press [NEXT] to select this parameter. Use the [+]

and [-] buttons.

Panel Lamp: High, Low, Off

This parameter allows you to adjust the instrument's panel lights. Press [NEXT] to select this parameter. Use

the [+] and [-] buttons.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 164 165

Kommentare zu diesen Handbüchern

Keine Kommentare

Rodgers Instruments W-5000 Betriebsanweisung Seite 136

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Musikinstrumente Rodgers Instruments W-5000